***********************************************************************
*                      U.S. ROBOTICS CORPORATION                      *
*                  U.S. Robotics 10/100 PCIO NIC TX                   *
*                    SCO Unix Driver Installation                     *
*                                                                     *
*               COPYRIGHT 2001 U.S. ROBOTICS CORPORATION              *
*                        All rights reserved.                         *
***********************************************************************

Installation Procedure
----------------------

1. Now login to UNIX system as supervisor (root) and enter the Maintenance 
   mode.

   Note: Make sure that the current directory is "/" using UNIX command --
	 pwd.

   Please follow the following steps to uncompress the package file:

   > cd /tmp 
   (and inserts the package floppy in the proper drive, i.e. a:)
   
   > doscp a:/SCO5/USR7900.sc5 ./VOL.000.000

   Now the installation directory is ready for use.

2. The following sections describe the configuration of the driver. It is 
   suggested that you should perform these instructions in the singler-user
   environment.

   Run "custom" utility and select the "Install new package" option.
   
   Select Media Type "Media Image" and type Image Directory "/tmp "
   It will prompt with "u79n Prototype Network Drivers (ver 1.0.0)"
 
   After running the custom utility and the new package is installed, you 
   should use the "netconfig" command to add the driver into your system 
   like the step 4 below.

3. Run "netconfig". Add the desired chain.

4. When the chain has been configured, select 'q' from the netconfig menu. 
   and relink the kernel at the prompt.
   
5. To activate the adapter, you must reboot.
