Windows NT 4.0

   Introduction:
   -------------
   This document describes the procedure to install  Windows NT v4.0
   driver for PCI ethernet adapter.

   Location of Driver:     \WINNT40\ETHPCI.SYS

   Installing driver procedure on Microsoft Windows NT :
   -----------------------------------------------------
   When you are in Windows NT 4.0:

   1. In the "Network" option in Control Panel, click the "Adapters" Tab.

   2. And then click "Add...", and then click "Have Disk...".

   3. Insert the PCI driver disk in drive A,enter drive and pathname
      A:\WINNT40  which is the path  where the driver ETHPCI.SYS and setup
      file OEMSETUP.INF are located, and then choose the OK button.

   4. The  screen will appear  "Input EthernetID"  dialog  box  which  is
      provided by ETHPCI.SYS driver. This option is only required when you
      have more than one PCI LAN adapters on this computer.
      Select SKIP if only one adapter is installed on this computer.

   5. NT will then perform the  "Bindings Configuration"  process. If any
      additional  network  software  options  were installed,  you may be
      prompted for specific information for these packages.

   6. Restarting your system you will acquire network service.

   NOTES:
   ------
      *  Installing Multiple LAN Adapters:

         Enter Windows NT and follow above setup procedure step 1,and then
         click  "Properties..." , and then the "Input Ethernet ID" dialog
         box appears and input adapter's Ethernet ID. Last step to select
         OK and close NETWORK SETUP.

         Select SKIP if only one adapter is installed on this computer.