*** Installing the NetWare server 3.1X Driver ***
      =================================================

   Use the LOAD and BIND commands to load the NetWare 3.1X server driver
 as described below. For more information on these commands, refer to
 the "NetWare 3.1X LAN driver installation documentation".

   The procedures are following:

 1. Install NetWare 3.1X on your system.
 2. Copy all the files from 3.1X server directory of the Driver Diskette
    to the hard disk directory ( for example, C: ) where the NetWare 3.1X
    system files are located. The path on the Driver Diskette should be
    as follows:
         A:\NOVELL\SERVER\3.1X
 3. Boot NetWare by executing SERVER.EXE. Refer to NetWare documentation
    on loading disk drivers and mounting volumes.
 4. To load the driver manually. simply follow the instructions given
    below.
    :LOAD C:PCNTNW FRAME=Ethernet_802.3 board=1
    :BIND IPX TO PCNTNW NET=xxxx

   The installation for Novell NetWare server 3.1X is now completed.

 ** NOTE: **

 Multiple FRAME type support

   To load multiple frame type for one physical PCI LAN board, the
 following should be entered:

    :LOAD C:PCNTNW FRAME=Ethernet_802.2 board=1
    :LOAD C:PCNTNW FRAME=Ethernet_802.3 board=1
    :LOAD C:PCNTNW FRAME=Ethernet_SNAP board=1
    :LOAD C:PCNTNW FRAME=Ethernet_II board=1

    Finally, the driver must be binded to the IPX protocol to each
 frame type.