Copyright: Copyright 1996 by TEAC Corp. All rights reserved.


About CDInfo

CDInfo is a utility supplied with the TEAC Changer CD-ROM Drive (hereafter "TEAC Changer Drive"). It performs the following tasks with respect to each of the disks in Slots 1 to 6 (indicated by the numbers 1 to 6 on the front bezel).

1. Displays information about and the volume label of the CD.

2. Ejects the CD.

3. Changes the current disk when in Single Drive Letter mode.

Operating Environment Requirements

* WindowsVer.3.1 and later must be correctly installed.

* The drive must be correctly recognized.

Important

*When more than one TEAC Changer Drive is to be connected to the system, a maximum of 24 drive letters can be used.

*TEAC cannot guarantee that CDInfo will function correctly if used with drives and device drivers other than those made by TEAC.

About the Shortcut Keys

About Single Drive Letter mode

About the Tool Bar

About Registered Trademarks


About the Shortcut Keys

CDInfo uses the following Shortcut Keys:

F1	: Opens the utility's Help file.

ALT+F4	: Quits the utility.


About Single Drive Letter mode

* Multiple Drive Letter mode:

When connecting a TEAC Changer Drive to a system, it is usual to install the special device driver. In this case, a drive letter is allocated to each slot of the TEAC Changer Drive. This mode is known as Multiple Drive Letter mode.

For instance, if the first drive letter allocated to a drive with 6 slots is E, the other slots will each be allocated a letter in alphabetical order as follows:

Slot 1	: E

Slot 2	: F

Slot 3	: G

Slot 4	: H

Slot 5	: I

Slot 6	: J

* Single Drive Letter mode

In Multiple Drive Letter mode, a drive letter is allocated to each slot of the drive. In Single Drive Letter mode, when a TEAC Changer Drive is connected to a system, drive letters are allocated to the drive as a whole rather than to each slot.

In Single Drive Letter mode, a single drive letter is used to access all the slots in the drive. To select the desired slot when using a TEAC Changer Drive in Single Drive Letter mode, either press the slot button of the drive you want to make current 3 seconds or more, or use CDInfo to change slots.

The current slot of the drive on startup is always Slot 1. If the drive letter assigned to the top of a 6-slot drive is E, the letter E will be allocated to Slot 1 on startup as follows:

Slot 1	: E

To make Slot 2 current, start up CDInfo and check the box for Slot 2. The drive letter allocation will then become

Slot 2	: E

and you will be able to access Slot 2.

Use the same procedure to make any other slot current.

Note:

To switch between Single Drive Letter mode and Multiple Drive Letter mode, execute the SETUP.EXE command from the TEAC Installation Disk.


About the Tool Bar

    |       |

    |       |

    |       |

    |       |__Quit:Quits this utility.

    |                When quitting, saves the current window size, position

    |                and display mode until the next startup.

    |

    |

    |______Check:Checks the disk in the currently selected slot.


About Registered Trademarks

 	Copyright(c) 1996 TEAC Corporation All Rights Reserved.

 	Windows is registered trademark of Microsoft Corporation.