How to use Flash Utility for TOMATO BOARD Please follow the steps as below: 1. Save bios image file and flash utility into a bootable floppy disk. 2. Start your computer with the floppy disk. 3. Run utility as follow: e.g. a) If your BIOS is AWARD BIOS: A:\AWDfl701 xxxxxxxx.BIN b) If your BIOS is AMI BIOS: A:\AMIFL814 xxxxxxxx.rom 4. Follows the Screen instructions to backup your original BIOS image into file from BIOS. 5. Follows the Screen instructions to upgrade your BIOS properly. 6.If any error was appeared and caused failure in BIOS upgrade processing, please use the backup copy of original BIOS image file to resume the BIOS. IN THIS TIME, DON'T POWER-OFF PC OR REBOOT PC. OTHERWISE, BIOS WILL CORRUPT AND CANNOT BE RECOVERY AGAIN. 7. When all of the procedures completed, restart your computer by screen prompt. Warning: Avoid power-off incidentally in upgrading procedure, or system would fail to reboot! In addtion, Please note following in BIOS setup: Before saving BIOS parameter, we must enter "CPU Configuration Setup" to correct CPU speed after loading "Auto Configuration with Optimal Settings".