U P D A T E  N O T I C E

                               for Triones
                    Bus Master EIDE/ATAPI Device Driver
                          for Intel Triton Chipset

                               Version 3.0

                             (October 1, 1995)


1.  Some ATAPI CD-ROM drives need different workarounds. These workarounds
    were added into the drivers. Now more ATAPI CD-ROM models are supported.
    The following CD-ROM drives were fully tested:
        MITSUMI FX400,FX400B,FX400C,FX400D
        SONY CDU55E,CDU76E,CDU77E,CDU78E
        HITACHI CDR-7730
        NEC CDR260R,CDR271,CDR272,CDR273
        TOSHIBA XM-5302B
        WEARNES CDD-120A,CDD-220,
        OAK EVALUATION
        PHILIPS LMS CM207

2.  New workaround about WD Caviar hard disk drives recommended by Western 
    Digital was used.

3.  In Windows 95 system, when entering the DOS mode, the original PIIX 
    configuration and drive configuration will be restored. There will be
    no more error message or garbage characters when exiting into the 
    DOS mode.

4.  The driver for Windows 95 now allows a maximum 64K data transfer size
    for one command. The performance is much better than before.

5.  For the previous versions, if a Windows 95 system was installed 
    without the DOS or Windows 3.1 pre-installed, for the following 
    device combination:
            0x1F0:  a DMA supported disk drive
            0x170:  a PIO only CD-ROM drive
    accesssing the CD-ROM sometimes would result in an "Exception 0E ..."
    error message.
    This issue now is fixed.