CPC091792

                The Complete Communicator for DOS
   How to View Faxes from a PC without Communicator Installed
                                
                                
This document is provided as "For your information" and as is.
Neither The Complete PC nor any of it's employees assume any
responsibility for consequences resulting from the use of the
following information nor can the Complete PC technical support
provide help with this document.  The user of said information
does so at his or her own risk.

The Complete Communicator was not written to support the viewing
of faxes at a PC without the board installed.  However, you can
view faxes if you have the appropriate files copied at the other
PC.

At the PC where the Communicator is installed, you will have to
modify the installation parameters to match the Graphic Adapter
and Monitor type of the other PC.  (Not necessary if the two PC's
have the same Monitor type, i.e. VGA).  For instance, if the PC
with the Communicator has a VGA screen and the other PC has an
EGA setup then you will have to modify the INSTALLC program to
match the EGA setup.  To do this:

Type INSTALLC at the C:\ prompt
Choose Modify Existing Parameters
Choose PC Configuartion.
Change the values to match the settings of the other PC.
Press F10 twice, and reboot the PC

There are three files that need to be copied into a \CC directory
(\CC must be on the same drive and directory as the Communicator
PC) at the other PC.

                           CFAXCRT.EXE
                          CONFIG21.CFX
                          CFAXVIEW.EXE

Once you have these files on the other PC, you should be able to
bring fax files to the other PC and use CFAXVIEW to look at them
at the \CC prompt.  Please refer to Command Line Interface
Appendix of your CCOM manual for more information on CFAXVIEW.
Remember to reset your INSTALLC settings back to the
configuration of the Communicator PC.