Windows 3.51 & 4.0 Introduction: ------------- This document describes the procedure to install Windows NT3.51 & NT4.0 driver for D-Link DRN-16CT Ethernet ISA Bus Adapter. Location of Driver: \WINNT\DRN16CT.SYS Installing driver procedure on Microsoft Windows NT : ----------------------------------------------------- When you are in Windows NT : 1. In the Main group of NT, select the "Control Panel" icon. 2. In the Control Panel window, choose the "Network" icon. 3. In the Network Settings dialog box, click the "Adapter" button. Then the window will show a network dialog box . Click 'Add' button. 4. There will show a 'Select Network Adapter' window, click 'Have Disk...' button. 5. Insert the D-Link DRN-16CT driver diskette in drive A, enter drive and pathname A:\ which is the path where the setup file OEMSETUP.INF are located, and then choose the OK button. 6. There will show a 'Select OEM Option' window, Choose D-Link DRN-16CT Ethernet ISA Bus Adapter Click 'OK' button. 7. The screen will appear "Input EthernetID" dialog box which is provide by DRN16CT.SYS driver. This option is only required when you have more than one D-Link DRN-16CT Ethernet ISA Bus Adapters on this computer. Select SKIP if only one adapter is installed on this computer. 7. NT will then perform the binding process. If any additional network software options were installed, you may be prompted for specific information for these packages. 8. Restarting your system you will acquire network service. NOTES: ------ * Installing Multiple LAN Adapters: Enter Windows NT and follow above setup procedure step 2,in the "Network Settings" dialog box, choose the "Configure.." button. The "Input Ethernet ID" dialog box appears and input adapter's Ethernet ID. Last step to select OK and close NETWORK SETUP. Select SKIP if only one adapter is installed on this computer.