DOS LAN Service

   Introduction:
   -------------
   This document describes the procedure to install NDIS driver on DOS
   LAN service for D-Link DRN-16CT Ethernet ISA Bus Adapter.

   Location of Driver:  \NDIS2\DOS\DRN16.DOS  (for DOS LAN Service)


   Installing driver procedure on DOS LAN Service :
   --------------------------------------------------
      Before you start with the installation process, make sure that
      DOS LAN Services is properly installed. Similarly, your adapter
      should also be properly installed in your client PC.

      1. Copy DRN16.DOS from your Driver diskette (A:\NDIS2\DOS) to DOS
         LAN Services subdirectory C:\NET .

      2. Under DOS LAN Service subdirectory C:\NET, run INSTALL

      3. The screen display some description. If it's correct, move
         highlight to "The listed options are correct" item ,then press
         ENTER.

      4. Move highlight to "Network Card", then press ENTER.

      5. Select "Change driver for network card." item, then press ENTER.

      6. Select "Network card not shown in list below..", then press ENTER.

      7. Insert the D-Link DRN-16CT driver diskette in floppy A, and
         specify the pathname A:\NDIS2\DOS, then press ENTER.

      8. D-Link DRN-16CT driver is now installed on your computer, reboot
         your computer.

      NOTES:
      ------
          Parameters for the PROTOCOL.INI file:

          AdapterID : This keyword is provided by DRN16CT, and is required
                      when more than one DRN16CT adapters exist on one
                      system.