LAN Server 2.0/3.0 Introduction: ------------- This document describes the procedure to install NDIS driver on DOS LAN Requester and OS/2 LAN server 2.0(or 3.0) for PCI Ethernet adapter. Location of Driver: \NDIS\DOS\LAN_S23\PCIND.DOS (for DOS LAN Requester) \NDIS\OS2\PCIND.OS2 (for OS/2 LAN Server) Installing driver procedure on DOS LAN Requester : -------------------------------------------------- 1. Insert the IBM LAN Support Program (LSP) Version 1.36 Diskette into your floppy drive A: . 2. Type A:\dxmaid and press . 3. The screen will display the IBM logo. Press twice until the "Environment Information" appears on screen. 4. Responds to the screen prompts, specifying the following values for each field,use the to toggle between choices. Make sure that the values given above are correct, then press to store your choices. 5. In process driver diskette menu, insert the ETHPCI driver diskette in floppy A,and specify your pathname A:\NDIS\DOS\LAN_S23,then press ENTER. 6. Follow screen instructions to complete the process. Simply pressing for each screen display will select the default options. Press until you reach the display prompting you to insert the LSP diskette. 7. Insert the LSP diskette as prompted. Press to acknowledge completion of the action. 8. A screen showing the current configuration detected will be displayed. It should show the ETHPCI adapter and the protocols already selected (i.e.,"IBM DOS NETBIOS" and "IBM DOS IEEE802.2 PROTOCOL for NDIS"). 9. Press . to save the new configuration. This completes the LSP installation. 10. Save the configuration and reboot your computer. Installing driver procedure on OS/2 LAN Server 2.0/3.0 : ------------------------------------------------------ Before you start with the installation process, make sure that OS/2 LAN Server is properly installed. Similarly, your adapter should also be properly installed in your server. 1. Copy PCIND.OS2 and ETHPCI.NIF files from your Driver diskette (\NDIS\OS2) to C:\IBMCOM\MACS. 2. Click the OS/2 LAN Service icon. 3. Select "Installation and configuration". The IBM logo should appear onscreen. 4. Click . 5. Select and press . 6. Select "Install or Configuration this Workstation." 7. Select server type, adding a server or domain controller. The "install or remove" selections should appear. 8. Select "Configure a component." 10. Click the "Configure" button. 11. Select "Configure workstation." 12. Select "PCI ethernet adapter" when prompted to identify you Network Adapter. Then click the button. 13. Select IBM NETBIOS from the list and click the button. 14. Select to confirm all selections. 15. Follow screen instructions to complete the process, selecting to accept default selections. 16. Continue pressing until your screen prompts you to backup old CONFIG.SYS and AUTOEXEC.BAT and create a new CONFIG.SYS and AUTOEXEC.BAT. Also select to confirm this. 17. Installation is complete now. Reset your PC by turning it off and on.