Server Driver for NetWare 4.x 5.x 6.x Introduction: ------------- This document describes the procedure to install the NetWare server driver for D-Link DGE-528T Gigabit Ethernet Adapter. Location of Driver: \NWSERVER\DGE528.LAN Installation Procedures : ------------------------- Before you start with the installation process, make sure that the Novell NetWare 4.x 5.x 6.x server is properly installed. Similarly, your adapter should also be properly installed in your server. 1. Insert the DGE-528T Driver Diskette into drive A and check the contents of subdirectory \NWSERVER, It should contain the following file : DGE528.LAN --> Novell NetWare Server Driver DGE528.LDI --> Novell NetWare Server Driver Installation Information File 2. At the NetWare prompt (indicated by the Server name), run the INSTALL.NLM program by typing: server name: LOAD INSTALL 3. Select "Maintenance/Selective Install" and press . 4. Select " LAN Driver Options (Configure/Load/...) " and press . 5. Press the key to specify other drivers to install. 6. Press and specify the driver path (D:\NWSERVER) and press . 7. The DGE528.LAN driver should appear in your choice list for the 'Select a LAN Driver' field. Choose this driver to start the driver loading and binding procedure. This will allow you to load and bind all 4 frame types supported by NetWare. 8. Add the LOAD and BIND statements you require to the server's AUTOEXEC.NCF file so that the LAN driver will load automatically each time the server starts up. Installation Notes: ------------------- 1.Installing Multiple LAN Adapters: The keyword "SLOT" is provided for multiple LAN adapters in a single server by the driver DGE528.LAN. So, add EtherID in LOAD commands. For example: LOAD DGE528 FRAME=Ethernet_802.2 NAME=LAN_A SLOT=1 BIND IPX TO LAN_A NET=11 LOAD DGE528 FRAME=Ethernet_802.2 NAME=LAN_B SLOT=2 BIND IPX TO LAN_B NET=22 2. The keyword "MEDIUMTYPE" is provided for specifying adapter's speed (10M/100M/1000M), add MEDIUMTYPE in LOAD commands. For example: MEDIUMTYPE=AUTO ----> Auto negotiation MEDIUMTYPE=1000FULL ----> 1000M FullDuplex MEDIUMTYPE=100FULL ----> 100M FullDuplex MEDIUMTYPE=100HALF ----> 100M HalfDuplex MEDIUMTYPE=10FULL ----> 10M FullDuplex MEDIUMTYPE=10HALF ----> 10M HalfDuplex LOAD DGE528 FRAME=Ethernet_802.2 NAME=LAN_A SLOT=1 MEDIUMTYPE=AUTO BIND IPX TO LAN_A NET=11