Novell NetWare Server 3.12
---------------------------

For a NetWare 3.12 server configuration, We provides a NetWare Server 3.12
ODI driver which is included on the ISA Ethernet Card driver diskette.

Note:
The directory structure provided on the ISA Ethernet Card driver diskette
has been setup for automatic OEM installation. Also, more information
can be found in the Novell NetWare 3.12 documentation.

Use the (LOAD) and (BIND) commands to load the NetWare 3.12 ODI server driver
as described below. For more information on these commands, refer to the Novell
NetWare 3.12 LAN Driver Installation documentation.

There are two methods for loading the NetWare Server 3.12 driver:
1) use the server command line prompt (":") or 2) edit the (AUTOEXEC.NCF) file.

Note:
If you use the server command line, you will need to load the driver each time
the system is booted. If you edit the AUTOEXEC.NCF file, it will automatically
load the driver each time your system is booted.

Follow the steps listed below:

1       Install NetWare 3.12 on your system.

2       Copy the ISA Ethernet Card's ODI Server driver (E200NW.LAN) from the 
        ISA Ethernet Card driver diskette to the hard disk directory where the 
        NetWare 3.12 system files are located. The following path should be 
        used to access the files from the ISA Ethernet Card driver diskette:

                A:\SERVER.ODI\3.12\E200NW.LAN

3       Boot NetWare by executing (SERVER.EXE). Refer to the appropriate
        Novell NetWare documentation on loading disk drivers and mounting
        volumes for more information.

4       To load the driver manually, follow the steps listed below. If you
        want to load the driver using (AUTOEXEC), go to step 5.

        Notes:
        1) You will need to specify the DOS path if the driver is located in
           a DOS partition.

        Type the following command at the file server console (which also
        changes the default settings for ISA EthernetCrads):

                LOAD E200NW PORT=320 INT=5

        The PORT, INT values used above should correspond to the ISA Ethernet
        Card's settings.


        Next, bind the driver to the IPX protocol stack by typing:

                BIND IPX TO E200NW NET=xxxx
                (Bind to IPX or any other protocol stack; where e.g., xxxx=1234)

        Then press <Enter>.

        The installation of the NetWare Server 3.12 driver is now complete.


5       To load the driver using (AUTOEXEC), you must first edit the
        (AUTOEXEC.NCF) file.

        * Type "LOAD INSTALL" at the server prompt (":") to access the Install
          Utility.

        * Open the "SYSTEM OPTIONS" menu to access "EDIT AUTOEXEC".

        * Then add the following command lines to the (AUTOEXEC.NCF) file.


        An example with the ISA Ethernet Card:

                LOAD E200NW INT=3 PORT=320 FRAME=Ethernet_802.2

                BIND IPX TO E200NW NET=xxxx
                (Bind to IPX or any other protocol stack; where e.g., xxxx=1234)

                You can load 4 frame type protocol at a time when the server is
                booted. To use this option you must load and bind another
                frame type protocol( Ethernet_802.3,Ethernet_II,Ethernet_SNAP ).

        The installation of the NetWare Server 3.12 driver is now complete.

        Notes:
        1) You will need to specify the DOS path if the driver is located in
           a DOS partition.

------------------------------------[ END] -----------------------------------