LAN Server 2.0 or 3.0
---------------------

   Introduction:
   -------------
   This document describes the procedure to install NDIS driver on OS/2
   LAN server 2.0 (or 3.0) for PCI Ethernet Card.


   Location of Driver:  \NDIS.OS2\W30ND.OS2  (for OS/2 LAN Server)


   Installing driver procedure on OS/2 LAN Server 2.3 :
   --------------------------------------------------
      Before you start with the installation  process,  make sure that
      OS/2 LAN Server  is properly installed.  Similarly, your adapter
      should also be properly installed in your server.

      1. Copy W30ND.OS2 and W30ND.NIF files from your Driver diskette
         (\NDIS.OS2) to C:\IBMCOM\MACS.

      2. Click the OS/2 LAN Service icon.

      3. Select "Installation  and  configuration".  The IBM logo should
         appear onscreen.

      4. Click <OK>.

      5. Select <Advance> and press <Enter>.

      6. Select "Install or Configuration this Workstation."

      7. Select server type, adding a server or domain controller.  The
         "install or remove" selections should appear.

      8. Select "Configure a component."

      10. Click the "Configure" button.

      11. Select "Configure workstation."

      12. Select "Slave PCI Ethernet Adapter" when prompted to identify you
          Network Adapter. Then click the <Add> button.

      13. Select IBM NETBIOS from the list and click the <Add> button.

      14. Select <OK> to confirm all selections.

      15. Follow screen instructions to complete the process, selecting
          <OK> to accept default selections.

      16. Continue pressing <OK> until your screen prompts you to backup
          old  CONFIG.SYS and  AUTOEXEC.BAT and create a new  CONFIG.SYS
          and AUTOEXEC.BAT. Also select <OK> to confirm this.

      17. Installation is complete now. Reset your PC by turning it off
          and on.


-----------------------------------[ END ]------------------------------------