ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
            º                                                  º
            º        Compex RL2000 PCI Ethernet Adapter        º
            º  Copyright (C) 1996 by PDS. All Rights Reserved. º
            º                                                  º
            ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ

ÚÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ¿
³ INSTALLATION GUIDE  ³
ÀÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÙ
 FTP PC/TCP Network Software For DOS
 ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ
     a) Install PC/TCP onto your system according the
        PC/TCP installation guide.

     b) Configure both Interface Software Driver and
        Protocol Driver.
     
        Use IPCONFIG.EXE to configure the Internet Protocol device
        driver, IPCUST.SYS. Similarly, use IFCONFIG.EXE to
        configure the Interface device driver,IFCUST.SYS. Please
        refer to the PC/TCP manual for further information.

     c) (This step is not required for PC/TCP version 2.10 and later.)
        After the file, CONFIG.SYS, which resides in the
        root directory of your startup disk, to install two
        device drivers, IPCUST.SYS and IFCUST.SYS. Insert the
        following two lines.

        DEVICE=[<DRIVE>]\[<PATH>]\IPCUST.SYS
        DEVICE=[<DRIVE>]\[<PATH>]\IFCUST.SYS

        NOTE: [<DRIVE>]\[<PATH>] refers to the full pathname
              of the directory containing the two device drivers.

     d) Reboot your system to load these configuration files.

     e) Load the hardware-dependant device driver included
        in the driver diskette for the network adapter.
          e.g.
                A:\PKT\RL2000PD   <ÄÄÙ Enter

     i) Before running PC/TCP applications, please load the
        Generic Kernel (ETHDRV.EXE), which will exchange
        information with the network adapter device driver.

     j) Now, you can start any PC/TCP applications.


Hint:-
       Type RL2000PD /? for help