ΙΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝ»
       Ί                                                              Ί
       Ί       Compex RL100ATX 10/100Base PCI Ethernet Adapter        Ί
       Ί        (C) Copyright PDS, 1998. All Rights Reserved.         Ί
       Ί                                                              Ί
       ΘΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΌ

RL100ATX 10/100Base-TX PCI Fast Ethernet Adapter Diagnostic Program
ΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝ

 ** IMPORTANT Notes:
    ΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝ

1) If you loading EMM386.EXE v4.49 ensure to exclude memory range D000-DFFF
   e.g. add this statement in Config.sys,
 
       Device=C:\DOS622\EMM386.EXE noems x=d000-dfff

2) Due to size of the diagnostic program, the diagnostic utility on the
   disk is compressed.
   To extract, create a directory in drive C: or to a blank formatted diskette
   and extract RLAXDIAG.EXE in to it.

   The following files will be extracted,
   RL100ADM.EXE, RL100ADM.INI, CYLU0.PKT, FA50.PKT, DIGITAL.PKT, and DWIO.SCR
   These 6 files must be in the local harddisk or floppy diskette for the
   diagnostic to run.

To execute the diagnostic, run,

    RL100Adm                          Run diagnosis program
    RL100Adm /g[=file_specify]        Generate NET.CFG as file_specify
    RL100Adm /n                       Run diagnosis program


Description diagnostic and its options:
ΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝΝ
    1. System
       .show node-id, port, irq, membase, ROM base (if available)
       .select a desired card from serveral RL100ATX cards
    2. (Cxx) Control/Status register test
       .registers read/write test
    3. Loopback Test
       .data structure test
    4. Practical Tx/Rx Test
       .receive test
       .transmit test
       .transmit and receive test
    5. Set boot ROM size