ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ»
         º                                                   º
         º         Compex EN2000N Ethernet Adapter           º
         º  Copyright (C) 1995 by PDS.  All Rights Reserved  º
         º         Release Date : Aug 24, 1995               º
         º                     (950824)                      º
	 º                                                   º
	 ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ

This is a reference for the Compex EN2000N Configuration Utility, Easyset.com.

With this utility, users can change the hardware settings on the Compex EN2000N
network adapters at any time easily.

     All the options are described briefly below.

          a) I/O Base
             The valid I/O base address are 0x240, 0x280, 0x2C0,
             0x300, 0x320, 0x340 and 0x360.

          b) IRQ
             Set your network adapter at an IRQ level not to
             be used by other I/O devices in your system unit. If
             the same IRQ level is used by your adapter and another
             I/O devices in your system unit, change the IRQ level
             to prevent conflict.

          NOTE:
             :- IRQ 10 and 11 can only be selected when the
             network adapter is in an AT slot.


          c) Cable Type
             There are 3 supported cable type.
              :- Twisted pair (TPI)
              :- Thin Ethernet (BNC)
              :- Thick Ethernet (AUI)

          A NOTE ON HOW TO USE THE AUI PORT FOR EN2000N-COMBO3 :

            To use the AUI port, jumper pins J3 and J4 MUST be shorted by a
            jumper and at the same time the adapter must be programmed
            to BNC mode via the Easyset program. To switch to use BNC port,
            short jumper pins J2 and J3 and of course with the card also
            programmed to BNC mode.


          d) PROM
             It specifies the starting address of the boot
             PROM. The supported address range is started from
             0xC800:0 and up to 0xD800:0.

          e) Late IO-16
             This option is set to Disabled. Do not enable it.

          f) Late CHRDY
             This option is set to Disabled. Set to Enable only if you
             want to make the adapter more compatible with the following
             chipsets:
               :- MX83C305FC, MX83C306FC
               :- SL82C461, SL82C465, SL82C362SX
               :- Suntac 62C251-A, Suntac 62C203-A
               :- M1414A1, M1217A1 (ALI)

Provided by:-
		Compex Inc.
		4051 E,La Palma
 		Anaheim, CA 92807
		USA