ÉÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ» º º º Compex EN2000N Ethernet Adapter º º Copyright (C) 1995 by PDS. All Rights Reserved º º Release Date : Aug 24, 1995 º º (950824) º º º ÈÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍͼ Packet Driver Installation For EN2000N Ethernet Adapter ------------------------------------------------------- The driver EN2PD.COM can be used for the following EN2000N Ethernet adapters: EN2000N-TP EN2000N-CX EN2000N-COMBO EN2000N-COMBO3 EN2PD syntax: EN2PD -i -b -q -n -k -i Set software interrupt number -b Set I/O Base address -q Set hardware IRQ -n Set NE2000 compatible -u Unload driver Example: The following command line loads the EN2000N Packet Driver at software interrupt 60h, I/O address 280h, and hardware interrupt Ah. EN2PD -i 0x60 -b 0x280 -q 0xA You may also simply type EN2PD the packet driver program EN2PD will search for the default I/O address and the default hardware interrupt. After the Packet Driver is loaded, you can run the PC/TCP kernel ETHDRV.EXE. The PC is then ready for PC/TCP communications. To run PC/TCP applications, You need to load PC/TCP Kernel ("ETHDRV.EXE"). a. Refer to PC/TCP manual, Command Reference section, Chapter 2.3. b. At this point, you are ready to run PC/TCP applications (e.g., 'ftp', 'telnet'). For example you may type FTP 192.72.24.202 where 192.72.24.202 is a host address. For information regarding the "FTP's PC/TCP Network Software for DOS" packages, please contact: FTP Software, Inc. 26 Princess Street Wakefield, MA 01880 (617) 246-0900 Provided by:- Compex Inc. 4051 E,La Palma Anaheim, CA 92807 USA