Contents:
  ---------

           A) Install NDIS 3.1 driver to the Windows 95
           B) Configure NDIS 3.1 driver to the Windows 95

A) Install NDIS 3.1 driver to the Windows 95
    The drivers named CN100E.SYS contained in the directory
    WIN95.


    NDIS Driver Installation on Windows 95
    --------------------------------------
    1. Plug CN100TX(E) adapter into one of the Master PCI slots of 
       your PCI platform.
    2. Turn power on then boot from Windows 95.
    3. Windows 95 will find and bind the DECchip 21x43 driver supported by
       itself, then configure your network environment.
    4. The system restart automatically.
    5. Windows 95 will prompt with PCI Ethernet Controller in New Hardware Found
       dialog box.
    6. Select "Driver from disk provided by hardware manufacturer" from New
       Hardware Found dialog box, then click OK button.
    7. Insert the CN100TX Driver Diskette in your floppy drive.
    8. Enter the driver pathname, i.e. A:\ (or B:\), then click the OK
       button in the Install from Disk dialog box.
    9. Follow screen instructions to complete the process.
   10. Restart your computer.



B) Configure NDIS 3.1 driver to the Windows 95

    1. Click the "My Computer" icon in the Main Program Group.
    2. Click the "Control Panel" icon in My Computer window.
    3. Click the "Network" icon in the Control Panel window.
    4. Select "Adapter" item from Network Component Type dialog box,
       then click the "Properties..." button.
    5. Click "Advanced" button in Properties for CN100TX(E) PCI Ethernet
       Adapter dialog box.
    6. Here, you can set the following properties:

       <1>. Burst Length : 1 Dword        ; Default is 16 Dwords.
                           2 Dwords       ; (1 Dword = 4 bytes).
                           4 Dwords
                           8 Dwords
                          16 Dwords
                          32 Dwords

       <2>. Connection Type (32-bit driver): <NDIS3 driver>
             for CN100TX(E) adapter      ; Default is AutoSense                               100BaseTx
                              100BaseTx Full_Duplex
                              10BaseT
                              10BaseT Full_Duplex
                              AutoSense

       <3>. Connection Type (16-bit driver): <NDIS2 driver>
            (This argument will be put in MAC driver section in PROTOCOL.INI)

                              Auto Detection    ; Default is Auto Detection
                              Twisted Pair
                              TP Full Duplex

       <4>. Receive Buffers : 8, 16, 32, 48, 64.
                              default is 16.

       <5>. Map Registers   : 4, 8,
                              default is 8.
                              This parameter depends on the specific machine,
                              for x86, the value is 8.

       <6>. Store And Forward : Enabled --> Enable early transmit,
                                Disabled--> Disable early transmit,
                                default is Disabled.

       <7>. Transmit Threshold : the transmit FIFO threshold level when Store and
                                 Forward is disabled.

                             10Mbps:  72,  96, 128, 160   bytes,
                            100Mbps: 128, 256, 512, 1024  bytes,
                            default is 160 or 1024 bytes.

       <8>. Data Rate-16 bit driver: the line speed of CN100TX(E) adapter,

                                     Valid data: 10Mbps, 100Mbps,
                                     default is 100Mbps.

    7. Follow screen instructions to complete the process.

    8. Restart your computer.