NetWare DOS ODI Workstation Driver Installation (NetWare v3.xx & v4.xx) ----------------------------------------------------------------------- This section describes the procedure to install the NetWare v3.11 workstation driver for your adapter. Installation Procedure: ----------------------- Before you start with the installation process, make sure that the adapter is properly installed and configured, and your NetWare operating system is properly installed. 1. Run the following command in the order given below and press : LSL MX32ODI IPXODI NETX (or VLM) 2. You can now log into your network. Installation notes: ------------------- 1. Remember to specify LASTDRIVE=Z in the CONFIG.SYS file. 2. Edit the NET.CFG if you want to change some parameters. For example, if you're using a NetWare 3.11 workstation and wants to log into a NetWare v4.X server. The default frame type of NetWare 3.11 is Ethernet 802.3, while that of NetWare v4.X is Ethernet 802.2. Before you can log into the NetWare v4.X , make sure there is a protocol binding for Ethernet 802.3 in the server's NET.CFG file. This is normally included in the [MLID] section. A sample NET.CFG file is given below: Link SUPPORT buffers 8 1514 mempool 4096 link driver MX32MLID frame Ethernet_802.2 frame Ethernet_802.3 frame Ethernet_II frame Ethernet_snap