Driver Installation for LAN Manager Workstation/Server

(1) Introduction:
-----------------
  This document describes the procedure to setup LAN Manager 2.1
  Workstation/Server driver for PRO120(A) PCI Fast Ethernet adapter.


(2) Location of Driver:
-----------------------
   (DOS) \MSLANMAN.DOS\DRIVERS\ETHERNET\MXNICF.DOS
   (OS/2)\MSLANMAN.OS2\DRIVERS\ETHERNET\MXNICF.OS2


(3) Sample Configuration Files:
-------------------------------
   %%% CONFIG.SYS (for DOS will contain) %%%
       DEVICE=C:\LANMAN.DOS\DRIVERS\PROTMAN\PROTMAN.DOS /I:C:\LANMAN.DOS
       DEVICE=C:\LANMAN.DOS\DRIVERS\ETHERNET\MXNICF.DOS


   %%% CONFIG.SYS (for OS/2 will contain) %%%
       DEVICE=C:\LANMAN.OS2\DRIVERS\PROTMAN\PROTMAN.OS2 /I:C:\LANMAN.OS2
       DEVICE=C:\LANMAN.OS2\DRIVERS\ETHERNET\MXNICF.OS2


   %%% PROTOCOL.INI (will contain) %%%
      [MXNICF_NIF]
      ; PRO120(A) RPOTOCOL.INI SAMPLE

        DriverName = MXNICF$

        ;; Range: 0-7.
        ;; Usage: "Board=nn"
        ;------------------
        ; Board = 0

        ;; Options: TX100, TX100FD, TX10, TX10FD, NWAY.
        ;; Usage: "MEDIA_TYPE=xxx"
        ;-------------------------
        MEDIA_TYPE = NWAY


(4) Setup Procedures:
---------------------
   Before you start with the installation process, make sure that the
   adapter is properly installed and configured. Make sure your
   Microsoft LAN Manager is properly installed.

   1. Run the appropriate Microsoft LAN Manager SETUP for computer you
      are setting up.(DOS, OS/2 or OS/2 Server). Select "Configuration"
      item ,(the PRO120(A)'s driver isn't included on the LAN Manager disk)
      and insert the driver diskette, select the PRO120(A) driver and
      follow the directions.

   2. When completed, reboot your computer .